User's Manual

panel
illumination
color: Slave
LCD panel illumination.
When the E3
+
transmitter is set as slave unit
（linked shooting）, select green as color of the
LCD panel illumination.
: AF assist
beam
Enable the AF assist beam
Disable the AF assist beam
VII. Trouble Shooting Guide
1. Power does not turn on
1.1 Make sure the batteries are installed in correct orientation.
1.2 Check battery contacts are in good contact and that the batteries are sufficient
with power.
2.The Slave unit doesn’t fire
2.1 Check if the slave unit supports radio transmission wireless flash
2.2 Set the slave unit to < >< >.
2.3 Set the transmission channels and wireless radio IDs of the master unit and slave
unit to the same numbers.
2.4 Check if the slave unit is within the transmission range of the master unit.
2.5 If using E3
+
receiver, please refer to the receiver’s manual instruction to check the
operation.
3. < >is displayed
Set the shutter speed 1 stop slower than the flash sync speed.
VIII．Technical Specification
Type On-camera wireless flash trigger
Compatible cameras EOS type-A camera compatible with E-TTL II/E-TTL autoflash
Exposure control
system
E-TTLⅡ/E-TTL auto, manual flash, stroboscopic flash, auto
external flash metering（only when the flash mode is set to
<Gr>）.
Frequency 2405 – 2475Hz
Modulation system Primary modulation: OQPSK, secondary modulation: DS-SS
Channel Auto, Ch.1-15
Wireless radio ID 0000-9999
Slave unit control Up to 5 groups（A/B/C/D/E）, up to 15 units
Transmission distance 100m+
Flash ratio control 1:8-1:1-8:1, 1/2-stop increments