User's Manual

1.1 Set the firing group of the slave units

Operate and set the slave unit group one by one. Set one unit to <A>, and set the other

to <B>. For the slave unit settings, see the flash or receiver’s instruction manual.

1.2 Set the ratio mode: Press the master unit’s function button 4 to display .

Press function button corresponding to to set to < >.

1.3 Set the flash ratio: Press function button 3 corresponding to , and again

press the function button 3 while it is corresponding to , turn< >to set the

flash ratio and press< >button. Press function button 4 corresponding to

to return to shooting-ready state.

1.5 Take the picture: the slave unit flash at the set flash ratio.

2. Autoflash Shooting with Thee Slave Groups

You can add firing group C to firing groups A and B. C is convenient to set lighting so

as to eliminate the subject’s shadow. The setting method is the same as “Autoflash

Shooting with Two Slave Groups”