User's Manual

1. Scanning while “AUTO” is set:

Press function button 4 to display , and then function

button 3 corresponding to . The channel is reset to one

with a good reception signal.

2. Scanning while Ch.1 to 15 is set:

Press function button 4 to display , and then function

button 3 corresponding to . The radio reception status is

displayed in a graph. The higher the peak of the channel in the

graph, the better the radio reception signal.

Turn< >to select from Ch.1 to 15, and press< >button to

return to shooting-ready state.

The color of <LINK>lamp changes depending on the transmission status of the master unit and

the slave unit.

Note: 1).If the transmission channels of the master unit and slave unit are different, the slave unit

does not fire. Set both to the same number, or set both to “AUTO”.

2).If the wireless radio IDs of the master unit and slave unit are different, the slave unit

does not fire.

ETTL: Fully Automatic Wireless Flash Shooting

transmitter attached to the camera (master) and a wirelessly controlled flash

(slave) can perform fully automatic wireless shooting.

1. Autoflash Shooting Using One Slave Unit

Color Status Description Action

Green Lit Transmission OK -

Red

Lit No connected Check the channel and ID

Blinking

Too many units

Master Units + slave units = 16units

or less

Error Turn the power off and on again