User's Manual

To perform wireless shooting, set the E3
+
transmittermaster unitand flashslave unit
with the following procedure.
1. Master unit setting: Check that is displayed.
2. Slave unit setting: For the slave unit setting, see the flash or receivers instruction
manual.
3. Transmission Channel/Wireless Radio ID Settings: To avoid interference with
wireless multiple flash systems using radio transmission that are used by other
photographers or with other devices that use radio waves (wireless), you can change
the transmission channel and wireless radio ID.
Use the following procedures to set the master units transmission channel and
wireless radio ID. Set the same channel and ID for both the master unit and slave unit.
For the slave unit settings, see the flashs instruction manual.
1. Press function button 4 until is displayed.
2. Set a channel: press function button 1 corresponding
to , turn < > to select from Ch. 1-15 or
Auto, and press < > button to finish the setting.
3. Set wireless radio ID: press function button 2
corresponding to , turn < > to select the
digit to be set and press < > button. Again turn <
> to select a number from 0-9, and press the <
> button.
4. Repeat step 4 to set the four ID digits one by one.
Press function button 4 for corresponding to
to return to the shooting-ready state.
5. When the transmission between the master unit and
slave unit is established, the <LINK> lamp lights
green.
4. Scanning the Master Unit Transmission Channels to Set
E3
+
transmitter is able to scan the radio reception status and set the master units
transmission channel automatically or manually. When the channel is set to AUTO,
the channel with the best reception signal is automatically set. When setting the
channel manually, you can set the transmission channel again while referring to the
scan results.