User's Manual

mode and flash output set on the master unit. Flash exposure compensation and other
settings set on the master unit will be automatically set in the flash (slave). You don’t
need to operate the slave unit.
E3
+
receiver can be used to receive wireless radio signal transmitted from E3
+
transmitter、Canon
ST-E3-RT Speedlite Transmitter or Canon flashes that is compatible with wireless radio
transmission.
Master: E3
+
Wireless Trigger for
Canon/Transmitter
Slave: E3
+
receiver
Master: Canon ST-E3-RT Speedlite
Transmitter
Master: Canon 600EX-RT Speedlite
Flash mode
E3
+
receiver supports two flash modes: ETTL and M
1. When the master unit is set to ETTL, you can shoot with advanced wireless flash lighting in the
same way as normal E-TTLⅡ/E-TTL auto flash shooting;
2. When the master unit is set to M, slave unit fires at the set flash output
3. When the master unit is set to Gr, you can shoot with a different flash mode （ETTL/M/ OFF）
for each group（A/B/C/D/E）.
Note:
1) After connecting flash with E3
+
receiver, please firstly turn on the flash, set the flash mode to
ETTL, and lastly turn on the receiver.
2) During wireless shooting, do not operate the flash.
3) E
3+
receiver does not support Multi flash mode. If master unit is set to Multi mode, the slave
unit using E
3+
receiver does not fire.
4) E3
+
receiver does not support Ext.A flash mode.
Setting the Slave Units
1. Setting firing group for Save Units
Set the firing group for slave units (up to 15 units) accordingly with the setting of master unit.