User's Manual

While the E3
+
receiver is on, press and hold power button and function button 1
simultaneously for 2 sec to enable lock function. The function can disable receiver’s
button operation. And “LOCK!” will be displayed on the LCD screen. Use this to
prevent the receiver function settings from being accidentally changed after you set
them.
Again press and hold power button and function button 1 simultaneously for 2 sec,
you can disable the lock function.
III.LCD Display
1.
Transmission Channel Ch.1-Ch.15and Auto
2.
Wireless radio ID 0000-9999
3.
Firing group Up to five groups (A/B/C/D/E)
4.
Battery power state
-
Slave units and master
unit in contact state
-
E3+ receiver in
contact state with
flash that attached
to its hot shoe
mount
-
IV. Wireless Flash Shooting: Radio Transmission
Note:
The transmitter attached to the camera is called the master unit, E3
+
receiver and a flash that is
wirelessly controlled is called the slave unit.
Wireless Flash Shooting
Set the master unit and E3
+
receiver’s to exactly the same channel and ID, and the flash
mounted on E3
+
receiver set to ETTL mode, the flash (slave) will fire at the flash