User's Manual

1.2 Double click to start the upgrade software. The upgrade software can be used to
check version info, and upgrade the Base software, RF software and Icon.
Click "Version" icon, the current version information of the connected E3
+
transmitter
will be displayed in the software window.
Click "Base software" icon, locate and double click on the FDS file from the pop-out
window. Then it starts loading the new firmware.
Click "RF software" icon, locate and double click on the RFC file from the pop-out
window. Then it starts loading the new firmware.
Click "Icon" icon, locate and double click on the FIF file from the pop-out window.
Then it starts loading the new firmware.
1.3 The status of the upgrade will be displayed in the process bar. When completed,
an "Updata OK" will be displayed at the bottom of the upgrade software window, and
an “update OK” will be displayed on the receivers’ LCD screen. Upon completion,
disconnect the USB cable and restart the E3
+
receiver.
Note:
Please ensure stable power supply when attempting to upgrade the E3
+
receiver. Loss
of computer power during the upgrade process could fail the upgrading.
Checking Version Info on E3
+
Receiver
You can check present version information on the E3
+
receiver: while pressing power
button to turn on the E3
+
receiver, press function button 1, 2 or 3 spontaneously until
relevant version info is displayed on the LCD screen. Function button 1, 2 and 3 is
respectively corresponding to base hardware & software version, RF hardware &
software info, and Icon version.
Test Firing:
E3
+
receiver supports test firing function. You can trigger the flash attached to E3
+
receiver by pressing test button<> on the receiver.
Attaching the E3
+
receiver to studio lights or flashes by cable
1) Turn off the flash/strobe and the E3
+
receiver
2) Connect a cable to the receiver’s 3.5 mm output port
3) Connect the opposite end of the cable to a flash or studio strobe
4) Turn on the flash/strobe and E3
+
receiver
5) Set the flash to Manual mode – no ETTL functions can be used when a compatible
flash is triggered by cable.
Lock function