User's Manual

1. Install batteries for the transmitter and receiver.
2. Press and hold the receiver’s power button and shutter button for 2s until the
indicator on receiver continuously blinks (5s).
3. Press the shutter button on transmitter one time to reset the code. When the
code is successfully set, the indicator on receiver will shortly stop blinking.
After that, it will go on blinking quickly, indicating that the receiver remains
in code setting state. You can continue to set the code to pair up with other
transmitters.
Note:
1) When a receiver in code setting state receives the first new code from
transmitter, all the codes memorized before that will be deleted automatically.
2) A receiver in code setting state can memorize up to 100 codes consecutively.
Using the Receiver as a Wired Remote without transmitter
1. Turn off the camera and receiver.
2. Connect one end of the cable to the camera’s remote port, and the other end to
the receiver’s remote release terminal.
3. Turn on the camera and receiver.
4. The shutter button will function exactly the same as the camera’s shutter: A
half-press of the shutter button will autofocus. A full press will take a photo.
When the camera is set to continuous shooting mode, press and hold the
shutter button will take photos continuously.
Note: The wired shutter release function is available when the receiver is turn off or
even without batteries.
Using the Transmitter as a Wireless Remote
1. Connect one end of the shutter release cable to the camera’s remote port, and the
other end to the receiver’s remote release terminal.
2. Turn on the camera and receiver.
3. Half press the shutter button on transmitter to autofocus. The indicators on the
transmitter and receiver will light green simultaneously.
4. Fully press the shutter button to take a photo. The indicators will turn red
simultaneously.
5. Pressing the delay button will take a photo in a 3 second delay. The indicator on
transmitter lights red. The indicator on receiver will blink green and orange in
sequence, and turn red when taking the photo.
6. Set the camera to continuous shooting mode. Press and hold the shutter button on
transmitter until the indicator turns off, and then let go off the button. The camera
will perform continuous shooting. To end the continuous shooting, press the