User's Manual



1. Power Button

2. Shutter Button

LED Indicator

4. Remote Release Terminal

5. Locking Ring

Cold Shoe/Tripod Lug

7. Battery Compartment

Turn on/off

1. Install batteries for the release remote: 1 pc of CR2032 battery for the transmitter,

and 2 pcs of AAA type alkaline or NI-MH batteries for the receiver. Make sure the

batteries are located according to the “ +/-“poles of the compartments.

2. Transmitter: Once the battery is properly installed, the indicator will light green

when half-pressing the shutter button, and turn red when fully pressing the button.

3. Receiver: Pressing the power button for 2s will turn on/off the receiver. When the

receiver is turned on, the indicator will flash green. The indicator will light green

when half-pressing the shutter button, and turn red when fully pressing the button.

Note:

1) When the battery of transmitter is exhausted, the indicator will not light up

when half pressing or fully pressing the shutter button. The transmitter will not

function. Please replace the battery with a new one.

2) At low power warning state, the indicator will blink red at certain frequency.

When the battery is exhausted, the receiver will not function. Please replace the

batteries with new ones.

Setting the Smart Code

The frequency will be pre-set in production, you can use the remote instantly. To

control the receiver with multiple transmitters, follow the below procedures to set the

smart code: