Specifications

- List of applicable FCC rules FCC Part 15.247
- Summarize the specific operational use conditions
This transmitter/module and its antenna(s) must not be
co-located or operating in conjunction with any other
antenna or transmitter. This information also extends
to the host manufacturer’s instruction manual.
- Limited module procedures not applicable
- Trace antenna designs It is “not applicable” as trace antenna which is not used on the module.
- RF exposure considerations This equipment complies with FCC RF radiation exposure limits set
forth for an uncontrolled environment. This compliance to FCC
radiation exposure limits for an uncontrolled environment, and
minimum of 50cm separation between antenna and body.
The host product manufacturer would provide the above information
to end users in their end-product manuals.
- Antennas
The module equipped with PCB Antenna（-0.35dBi, 2.412 GHz to 2.462GHz）.
- Label and compliance information The end product must carry a physical label or shall use e-labeling
followed KDB784748D01 and KDB 784748 stating “Contains Transmitter Module FCC ID: 2ATRRWF1009”.
- Additional testing, Part 15 Subpart B disclaimer The modular transmitter is only FCC authorized for
the specific rule parts (FCC Part15.247) listed on
the grant, and that the host product manufacturer
is responsible for compliance to any other FCC
rules that apply to the host not covered by the
modular transmitter grant of certification. The final
host product still requires Part 15 Subpart B
compliance testing with the modular transmitter
installed when contains digital circuity.
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01
2.2
2.3
2.4
2.5
2.6
2.7
2.8
2.10