User's Manual
Table Of Contents
- 1.0 Introduction
- 2.2.3 Camera Live Menu Function Introduction
- 3.0 Wi-Fi Wireless
- 4.0 Remote Access Setup
- 5.0 Camera Settings
- 6.0 Troubleshooting
- 7.0 Installation Instruction
- 7.1 3G Solar Camera Install
- FCC STATEMENT :
- This device complies with Part 15 of the FCC Rules
- (1) This device may not cause harmful interference
- (2) This device must accept any interference recei
- Warning: Changes or modifications not expressly ap
- NOTE: This equipment has been tested and found to
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
- FCC Radiation Exposure Statement:
- This equipment complies with FCC radiation exposur
- 86 -
Note: The default IP address of the camera is 192.168.168.100. This can be changed to any IP address on your IP
range. For example if the IP address of your PC is 192.168.1.52 then the IP address of your camera should be
unique and on the same subnet, i.e. 192.168.1.X where X is any number between 1 and 255 except 52. Ensure the
IP address you chose is not the same as other devices on your network as this will result in conflict and may cause
the device to not work properly.
6. Once you’ve entered the details click “Apply” then “Exit
Appendix D: Enabling Active X in Internet Explorer
Your browser must have Active X enabled to view the camera in Internet Explorer. To activate this, do the
following: