User's Manual
Table Of Contents
- 1.0 Introduction
- 2.2.3 Camera Live Menu Function Introduction
- 3.0 Wi-Fi Wireless
- 4.0 Remote Access Setup
- 5.0 Camera Settings
- 6.0 Troubleshooting
- 7.0 Installation Instruction
- 7.1 3G Solar Camera Install
- FCC STATEMENT :
- This device complies with Part 15 of the FCC Rules
- (1) This device may not cause harmful interference
- (2) This device must accept any interference recei
- Warning: Changes or modifications not expressly ap
- NOTE: This equipment has been tested and found to
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
- FCC Radiation Exposure Statement:
- This equipment complies with FCC radiation exposur
- 82 -
Wait 3-5 minute till the warning message “ Caution ! Upgrading Firmware! Please don’t turn off power or reset the camera till firmware
upgrade successfully” displayed.
Till warming message above displayed, then Wait 2-3 minutes again till the message. After the upgrade completes, you
will be prompted “ Firmware upgrade successfully, reboot now ?” to reboot the camera, then click “reboot”, after this
your latest firmware will be recorded.
You can check the camera firmware version in camera “system” ,which is on the top of the right corner .you will get to
the screen . If your firmware upgrade succeed, then the firmware version will be updated.