User's Manual
Table Of Contents
- 1.0 Introduction
- 2.2.3 Camera Live Menu Function Introduction
- 3.0 Wi-Fi Wireless
- 4.0 Remote Access Setup
- 5.0 Camera Settings
- 6.0 Troubleshooting
- 7.0 Installation Instruction
- 7.1 3G Solar Camera Install
- FCC STATEMENT :
- This device complies with Part 15 of the FCC Rules
- (1) This device may not cause harmful interference
- (2) This device must accept any interference recei
- Warning: Changes or modifications not expressly ap
- NOTE: This equipment has been tested and found to
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
- FCC Radiation Exposure Statement:
- This equipment complies with FCC radiation exposur
- 79 -
[Current device time] Internal time of the camera.
[Proposed device time] PC system time. On clicking Apply the internal time of the camera will be changed to this
time.
[Select to change the time zone for the device location] Choose your time zone.
[Daylight saving time] tick the box to enable daylight saving time. [Date
and Time format] Select the format of the date and time.
[Auto time setting (SNTP)] Enable or disable the auto time setting to update to the server below.
[Time server] Type the SNTP server name. There are suggestions included.
Note:
1.
If the SNTP server is not found the camera’s time will be synchronized with the PC time.
2.
The camera keeps track of the time even when power is disconnected.
Click Apply to confirm your settings.
5.9.4 Backup and Reset
Allows you to reset the camera to factory defaults, backup the configuration in case of accidental reset and restore
settings from a backup.