User's Manual

‐ 75 ‐
1.
Enter a unique name for the camera, the location (optional) and leave the default port number as 80. “Obtain an
IP address automatically” and “Obtain DNS server address automatically” are selected by default, if you are
confident enough to enter your own settings, you can do so by selecting “Use the following IP address” and follow
the guidelines on the next page.
2. To obtain the IP addresses specific to your network, click “Start” then “Run” and type “cmd” in the text box and
click “Ok”. This will bring up the MS‐DOS prompt. In this window type “ipconfig/all” and press enter. A screen
similar to the one below will be displayed.
3.
Take note of the following:
a.
IP Address
b.
Subnet Mask
c. Default Gateway
d.
DNS Servers (Both numbers with the first being the primary DNS server and the second being the secondary DNS
server)
4. Enter the details noted in step 6 into the relevant fields in the setup.
Note: The default IP address of the camera is 192.168.168.100. This can be changed to any IP address on your IP
range. For example if the IP address of your PC is 192.168.1.52 then the IP address of your camera should be
unique and on the same subnet, i.e. 192.168.1.X where X is any number between 1 and 255 except 52. Ensure the
IP address you chose is not the same as other devices on your network as this will result in conflict and may cause
thedevicetonotworkproperly.
6. Once you’ve entered the details click “Apply” then “Exit