User's Manual

‐ 74 ‐
For the next camera, you call the first application Cam2HTTP and use public TCP port 8151 while still using “map to
host” port 80. The second application would be Cam2RTP with UDP ports 30002‐30003 and map‐to‐host port 30002.
Appendix C:
Manually entering TCP/IP Settings for a Camera
In most cases, this is not required as the router will assign the correct settings to the camera. It is however useful if
you want to setup the TCP/IP settings of the camera before you connect to it, if DHCP is disabled across your
network, or if you have subnet network problems.
Assigning an IP address to the Camera with Camera Setup utility
1.
Launch Camera Setup to detect the camera on your local network.
2.
Select a camera, click on “Setup” and the following setup interface will pop up. Enter the default setting as
below:
User name : admin; Password: admin