User's Manual

‐ 16 ‐
2.3.1 Apple Airport Remote Access Setup
In order to access the camera remotely from outside your network, you have to tell your Airport to allow access t o
the network ports used by the camera.This is called “port setting” and is done with Airport utility as follows:
In the Airport Utility version 6.3.1, go to manual setup and select the “Network”
icon. 1. Click on the + (add) button below the “port setting”.
2. then click on the
+(add)
icon at the bottom of the box , and enter the following info:
Public UDP port: 30000‐30001 (next camera would have 30002‐30003 etc)
Public TCP port: 8150 (your 2
nd
camera would have 8151 here, 3
rd
8152
etc) Private IP address: (add the IP address for your camera, e.g.
10.0.1.201) Private UDP port: 30000‐30001 (same as public UDP port)
Private TCP port: 80
3. Then click on “save” , “Update” and “Continue” to restart your airport.
Now some from the outside your network should be able to access your camera using your external IP address with:
8150 added to the end. For example, if the Airport summary screen shows your IP address as 192.168.168.120, you
would enter the following in your browser: http://192.168.168.120:8150.