User Manual

E-mail Alarm setup

NC601 can transfer the image via E-mail. The alarm/timer trigger can be set on Motion Detection

window.

[Motion detection] Trigger to the alarm

[Periodical send] Trigger to the alarm

[Interval time] Sending image frequency when enable the Periodical send trigger

[SMTP server name] Type the name or IP address

of the SMTP server you want to use for sending an e-

mail

[SMTP server port] The default value is 25

[Authentication] Select the authentication required when you send an e-mail.

[User name] & [Password] Type the user name and password of the user who has the mail account.

This setting is necessary

when the SMTP server which sends e-mail performs authentication

[Re-type password] Re-type the password above to confirm

[Sender e-mail address] Set the e-mail address by which you want to send e-mail

[Receiver e-mail address] Set the e-mail address by which you want to receive e-mail(Up to 3 receivers'

e-mail address can be

set)

[Subject] Subject of the alarm e-mail

[Message] Description of the e-mail

[File attachment] Attach images shot by network camera or not (On/Off).

Note:

The Alarm mode , which uses the Network Camera internal clock., can send the e-mail without transferring the image.

Make sure Date and Time has been configured.