User Manual

PPPoE setup

The NC601 can be installed alone without PC on the network. Some XDSL services use PPPoE (Point-to-

Point Protocol over Ethernet ).

[PPPoE dial-up] Enable or disable PPPoE connection

[e-Mail notification] Remind you with IP address of your NC601 if Enable selected. The precondition is

that you have set the relative

parameters in your e-mail set (Refer to page 40 for E-mail alarm setup).

[Service name] Either an ISP name or a class of service that is configured on the PPPoE server.

[User name] Type a user name.

[Password] Type a password.

[Re-type password] To confirm the password, type the same characters

as you typed in the Password

box.

Click on Apply to confirm your settings.

How to access via PPPoE connection

1. After the , reboot your network camera.

2. Connect the camera to internet. Refer to Wired Network-Type 3. Internet Direct Connection with a

Modem on the network on Page 12.

Thus you can access your camera via DDNS or IP address reminded by e-mail.

setup