User Manual

Setting IP Address of the PC
1. Follow the steps below, appropriate for your operating system to open TCP/IP Properties window on the
PC.
Windows 2000
[Start] –> [Settings] –> [Control Panel] –> [Network and Dial-up Connections] –>
[Local Area Connection Icon] in use –> [Properties] –> Select Internet
Protocol [TCP/IP] –>
[Properties] –> [Use the following IP address]
Windows XP
[Start] (–> [Settings]) –> [Control Panel] –> [Network and Internet Connections] –>
[Network Connections] –> [Local Area Connection Icon] in use –> [Properties] –> Select Internet
Protocol [TCP/IP] –> [Properties] –> [Use the following IP address]
2. TCP IP Properties window appears. Set "192.168.0.X” in the IP address data field and "255.255.255.0"
in the Subnet Mask data field (X can be 0~255 except 100). This makes the camera and your PC in the
same net segment.
3. Click [OK].
Shield Cover
Note:
If you forget your settings, you can remove the shield cover, press the RESET button on the NC601 to enable the default
settings. You may refer to the Default Settings section on page 52~53 for more details.
16