User Manual

Network Parameters
How to refer the network parameters from the PC
If you cannot get the network parameters, you can refer to the network parameters except for IP address
from the PC on the same network in the following procedure.
When using Windows 2000 or Windows XP
1. Click [Start] –> [Program] (–> [Accessories]
) –> [MS-DOS® (Command) Prompt]. MS-DOS Prompt
window opens. These steps are slightly different depending on the operating system.
2. Enter "ipconfig /all" and press [Enter].
3. Enter "exit" and press [Enter] to close the window.
15
Use IP Finder to find IP address of your network camera
1.
Connect your NC601 and PC with RJ-45 cable.
2. Double-click icon . The following window appears. IP address may differ according to different
network environment. Take the 192.168.0.100 as example: