User's Manual

4. Connect the adapter (DC 5V 2A) to the receiver and slide the
power switch to ON position. The power indicator lights up green.
Power ON/OFF
The receiver also can work with Li-battery; load Li-battery to the compartment
with their polarities matched.
You are recommended to fully charge the li-battery before its first installation
to optimize its life.
The Li-battery will be charged after the adapter (DC 5V 2A) is plugged in. The
charge indicator will light up red during charging and will turn green after a full
charge.
A full charge will take about 220 minutes hours, which can power the receiver
for about 180 minutes continuously.
Charge the li-battery once you see a red icon bickers on the LCD.
Do not burn or disassemble the Li-battery.
Do not short-circuit the battery, it may cause fire or electric shock.
You also can charge the receiver by base charger. Please locate the receiver
to the base charger, then connect it with the adapter (DC 5V 2A). The receiver
will be charged. (Optional)
3. Rotate the camera to a suitable angle for surveillance.
180°
Note:
9