User's Manual

Channel-scan Set
Manual Mode (Default)
Channel-scan Mode
M:
L:
Tip:
You could also activate channel-scan function by pressing and holding the
Channel Select Button more than 5s at Manual mode and deactivate
it by pressing the button again.
"CH"
CHANNEL
M
ON
OFF
1. Manual mode: Slide Mode Control switch to M to enter Manual
mode. In this mode, the receiver channel won't change until you
press the Channel Select Button ;“CH"
12
they will be skipped during the Manual mode or Channel Scan mode.
Note:
If all channels are on OFF position the default setting is CH1.
2. Channel Scan mode: Slide Mode Control switch to L enter channel
scan mode. In this mode, all the available channels will display one
by one looping in turn per 5s. So you can watch the situations from
4 different cameras via one receiver. Slide the Mode Control switch
to M to exit.
Channel Select Button "CH”
Notes:
Press the Channel Select Button at the channel scan mode, the current
channel will be switched to the next one immediately (less than 5s).
“CH"
Press and hold more than 5s to activate;
Press again to deactivate.