User Manual

Channel-scan Set
Manual Mode (Default)
Channel-scan Mode
M:
L:
Notes:
Press the Channel Select Button at the channel scan mode, the current
channel will be looped to the next one immediately.
Slide the Mode Control switch to M to exit the channel scan mode.
"CH"
Tip:
You could also activate channel-scan function by pressing and holding the
Channel Select Button more than 5s at Manual mode and deactivate it
by pressing the button again.
"CH"
Channel Select Button "CH”
Press and hold more than 5s to activate;
Press again to deactivate
CHANNEL
M
ON
OFF
1. Manual mode: Slide Mode Control switch to M to enter Manual
mode. In this mode, the receiver channel won't change until you
press the Channel Select Button ;"CH"
2. Channel Scan mode: Slide Mode Control switch to L to enter
channel scan mode. In this mode, all the available channels will
display one by one looping in turn per 5s. So you can watch the
situations from up to 4 different cameras via one receiver.
12