User Manual

The receiver can support up to 4 cameras working at the same time.
You are allowed to set the Mode Control as described below. The
Mode Control has the precedence over other buttons.
Default Setting
Receiver Mode Setup
1
CH1 Enable (Default)
CH1 Disable
ON:
OFF:
2
CH2 Enable (Default)
CH2 Disable
ON:
OFF:
3
CH3 Enable (Default)
CH3 Disable
ON:
OFF:
4
CH4 Enable (Default)
CH4 Disable
ON:
OFF:
You can confirm which channel is set to receive signal from correspond-
ing camera. With this function, you could set the unused channels to
OFF, so that they will be skipped during the Manual mode or Channel
Scan mode.
Channel Set
CHANNEL
M
ON
OFF
CHANNEL
M
ON
OFF
11