User's Manual

The receiver can support up to 4 cameras working at the same time.
You are allowed to set the Mode Control as described below. The
Mode Control has the precedence over other buttons.
Receiver Mode Setup
1
CH1 Enable (Default)
CH1 Disable
ON:
OFF:
2
CH2 Enable (Default)
CH2 Disable
ON:
OFF:
3
CH3 Enable (Default)
CH3 Disable
ON:
OFF:
4
CH4 Enable (Default)
CH4 Disable
ON:
OFF:
You can confirm which channel is set to receive signal from correspond-
ing camera. With this function, you could set the unused channels to
OFF, so that they will be skipped during the Manual mode or Channel
Scan mode.
Note:
If all channels are on OFF position, the default setting is CH1.
Channel Set
10