User's Manual

aee.com
6
Device Power Supply
Remote control Load 4 AA batteries for power supply
Wi-Fi Repeater Wi-Fi Repeater should be charged through the inbuilt charging port (Mini USB port)
Quadcopter Charge quadcopter batteries for power supply
Mobile devices Please ensure that your mobile device is fully charged before using App
The following instructions are for the quadcopter battery�
1.1 Quadcopter Battery Introduction
The quadcopter battery (Figure 3) is a specically designed battery for Quadcopter with charge and discharge management functions, with voltage of 11.1V. Only
use the dedicated quadcopter battery charger (Figure 4) provided by AEE, for charging.
Figure 3 Figure 4
Short press the Battery Level Check button (Figure 5)� Battery Level LCD Segment Display displays appropriate battery level� Please fully charge the battery if it is
less than two bars�
Battery Level
Check button
Battery Level
(Segment Display)
Figure 5
Battery Specications
Type Li-Po Battery
Charging ambient temperature 0°C-50°C / 32~122°F
Discharging ambient temperature -20°C-50°C / -4~122°F
Charge / discharge ambient relative humidity < 80%
Please carefully read and strictly comply with this manual before use� Users take full responsibility for any problems caused due to failure to follow instructions�
1.2 Charging the Quadcopter battery
(1) Connect the charger to an AC power source (100-240V, 50 / 60Hz). Please use a power adapter, if necessary.
(2) While charging, the battery charger indicator turns red.
(3) When the battery charger indicator turns green, the battery is fully charged. Disconnect the charger and battery when charging is complete.
Figure 6