User's Manual

25
aee.com
25
Appendix
1 Description of Common Indicators
Normal State
Front and Rear Indicators remain ON; Tail Indicator remains on.
The GPS signal is strong enough�
Front and Rear indicators remain ON, Tail Indicator Slow Blinks Searching for GPS signals
Warnings and Abnormal State
Front and Rear Indicators Slow Blinks Low Power alarm (rst-level low power alarm)
Front and Rear Indicators Fast Blink Severe Low Power alarm (second-level low power alarm)
Above indicator descriptions refer to common LED indicator states. For specic details, please refer to “Prepare the Quadcopter” in section 2.3 Flight Indicators.
2 Specications
Quadcopter
Weight
1�65kg / 3�64lbs
Hovering Accuracy Horizontal: ±2.5m / 8.2ft , Vertical: ±0.8m/2.62ft
Maximum Tilt Angle 30°
Maximum Climb / Descent Speed
Climb: 6 m/s (19�69ft/s); Descend: 4 m/s (13�12ft/s)
Maximum Flight Speed 20m/s(65.62ft/s)(Not recommended)
Diagonal Length
450mm / 1�48ft
Flight Time 20min
Camera
Sensor Size
1 / 2�3
Effective Pixels 16 Megapixels (MP)
Resolution 4608x3456
HD Video Recording Maximum 1080P / 60fps (N system), 1080P / 50fps (P system), 720P/120fps
Remote control
Data Transfer Distance ≤700m (2296ft)
Working Hours 20h
Operating Current / Voltage 150mA / 6V
Battery 4 AA Batteries
Wi-Fi Repeater
Operating Frequency
2�4GHz
Communication Distance (open outdoors) ≤500m (1640ft)
Transmitting Power ≤17dBm
Power Consumption
1�5W
3 Common Troubleshooting
3�1 Solution for remote control joysticks center (neutral) position errors
When there is a big error in neutral position of remote control joysticks, the motors cannot start when performing CSC. Errors in Remote control joysticks neutral
position usually occur in two cases:
1. When quadcopter is ON and the joystick (except throttle) is not in neutral position-Solution: Move all Remote control joysticks to neutral position, and re-start the
quadcopter, to re-record the neutral position. If problem persists, it may be caused due to case.
2. Remote control joysticks have been trimmed, leading to deviation in neutral position, i.e., there is a large asymmetry in quadcopter joystick position-Solution:
Recalibrate the Remote Control�
a) The S2 switch is used for calibration of the joystick� Turn S2 to position 3
S2:
, then turn on the remote control, and at this time the status indicator starts
blinking (indicating joysticks calibration starts)� Turn the left and right joysticks clockwise and counter-clockwise respectively at the maximum stroke for two
circles, and then release the joysticks. (ensure that the joysticks stay at the maximum stroke throughout this process) Then, the status indicator in the middle
will go out. Last, turn S2 to position 1
S2:OK
, the photo shooting & video recording indicator will come on (green) and then go out 3s later. Now the calibration
completes successfully�
(b) Re-start the quadcopter, and pay attention whether or not it starts properly. If the problem cannot be solved by the above methods, please send back the remote
control to our factory for repair�
3.2 Solutions for Accelerometer Abnormalities