User's Manual

21
aee.com
21
T
oggle Left joystick to left bottom corner
T
oggle Right joystick to right bottom corner
GPS
NRM
S1 S2 S3 S4
GPS
NRM
D
F M
S
E
S1
D
S
E
S1: E S2: OK S3: Middle S4: GPS
S2
S3
S4
NULL
NULL
When S4 switch is set to GPS Mode,
S4
The motor cannot be turned on until GPS is ready (Tail
indicator will alternate between fast blinking and on)�
Figure 20
2.2 Stopping the Motors
There are two ways to stop the motors�
Method One (Figure 21):
After the quadcopter lands, toggle the throttle joystick to the lowest position and then perform CSC, the motors will immediately
stop� Release both joysticks after the motors stop�
Method 2 (Figure 22):
After the quadcopter lands, toggle the left joystick to the lowest position and hold for 3 seconds to stop the motor.
Figure 21 Figure 22
● Do not execute CSC during normal ight. This will stop the motors and cause the quadcopter to drop without control.
● Camera will stop recording automatically after motor stopped.
●
Toggle the joysticks quickly and accurately when performing CSC� Release the joysticks simultaneously after the motors starts or stops�
● Shutdown remote control must be after the quadcopter power off. Otherwise, the quadcopter will enter the return mode, then may case the high-speed rotation
of the propeller�
3 Basic Flight
3.1 Basic Flight Procedures
(1) Place Quadcopter on a at and open ground, and ensure Tail Indicator faces you.
(2) Power on the Camera, Remote control, Wi-Fi Repeater and Quadcopter one after the other.
(3) Launch AEE AP+ App, connect the mobile device and Quadcopter, and navigate to the Camera Preview interface.
(4)Start the motors until the GPS signal is strong enough(the Tail indicator remains on and Status Indicator is green.) at GPS mode. Or, start the motors when the
status indicator on Remote control is blue at NRM mode.
(5) Push the left joystick up slowly for a smooth take-off� Please refer to Remote control operation instructions for detailed operation procedures�
(6) Use the AEE App to capture photos and record videos, and enjoy the ight. Please refer to Using AEE AP+ App for more details.
(7) To land, gently pull down the left joystick to make the quadcopter descend slowly to the ground.
(8) After landing, execute CSC or pull the left joystick to the lowest position and hold for more than 3 seconds until the motors stop.
(9) After motors stop, power off Quadcopter, Wi-Fi Repeater and the Remote control one after the other.
● During ight if all 4 arm indicators slow blink or fast blink, it indicates the quadcopter has entered a low battery state. Please refer to Low Battery Level Alarm
Function for details�
● DO NOT move the camera manually in any case OTHERWISE it will cause the camera to be abnormal. The movement of camera can be controlled only by the
Remote Control�
General Operating Order List
Component Startup Time
Turn on the quadcopter
Start the APP on the
mobile device
Perform the takeoff
operation of the
quadcopter
Camera 20s
Repeater 22s
Remote control 10s
Tracker 10s