User's Manual

aee.com
20
Flight
After installation, please conduct ight training (for example: Flight simulator training or professional training). Ensure that all ights are carried out in a suitable
environment�
Flight Environment Requirements
(1) Do not use the quadcopter in severe weather conditions, such as strong winds (category 4 and above), snow, rain and fog.
(2) Fly in an open area without tall buildings� Presence of large number of steel buildings in the area will affect the onboard compass�
(3) Keep Quadcopter away from obstacles, people, power lines, trees, shelters, surface of the water, etc., during ight.
(4) Reduce the chance of electromagnetic interference by not ying in areas with high levels of electromagnetism (such as near mobile phone base stations or
towers)�
(5) This product cannot be used in The Antarctic Circle and The Arctic Circle�
(6) Do not y the quadcopter within restricted or no-y zones, and abide by local laws or regulations.
Pre-ight Check:
(1) Ensure Remote control, Quadcopter, Wi-Fi Repeater and mobile device are fully charged.
(2) Ensure propellers are correctly assembled�
(3) Ensure the Micro SD card is properly loaded before photo capture and video recording�
(4) Ensure the Quadcopter, Remote control and other equipment are working properly after powering on.
(5) Check if motors start properly after the quadcopter is switched on. At this time, disassembling propellers is recommended for safety.
(6) Check if the AEE AP+ App is properly connected to the camera�
1 Compass Calibration
Compass calibration is required before rst time use otherwise the system may not work properly, af
fecting ight safety. The compass is sensitive to electromagnetic
interference from other electronic devices, which can cause abnormal compass data leading to poor ight performance or even ight failure. Regular calibration is
required for optimum performance�
● Do not calibrate the compass in a strong magnetic eld.
● Do not carry ferromagnetic material, such as keys, cell phones, etc., while calibrating the compass.
1.1 Calibration Procedures
Choose an open space to conduct calibration� Start the Remote control and quadcopter and ensure they work properly� Follow the below procedures to calibrate the
compass:
1 2 3 4 5
S4
GPS
NRM
F M
After the quadcopter powers
on(about 20 seconds). Swich S4
for more than 5 times between
GPS and Follow Me mode. The
quadcopter will enter calibraion
standby mode(the tail light blinks
fast).
Toggle the joysticks to the
position as in the follow figure.
Front indicator (green) starts
blinking ,Then release the
joysticks.Compass calibration
command has been sent
successfully.
Rotate Quadcopter 360°
horizontally
(2 turns)
Rotate Quadcopter 360°
vertically
2 turns (Nose down )
Rotate Quadcopter vertically (Nose
leftward)until green lights off, Put
Quadcopter on the ground. Green
lights up normally after light off→
calibration successful; Green lights
blink fast after light off→calibration
failed →Recalibrate
Warning
Be sure to remove propellers before calibration, to avoid accidental injury or loss.
1.2 When to Recalibrate
(1) When compass data is abnormal, front indicator (green) blinks fast.
(2) The ight location is far from the place where last compass calibration was conducted.
(3) There are changes in quadcopter’s physical structure�
(4) The quadcopter drifts a lot while ying , such as it ies along a circle when hovering.
2 Starting / Stopping the Motor
2.1 Starting the motor
Toggle the joysticks as shown in the illustration (Combination joystick Command [CSC]) to start the motor� Release the joysticks simultaneously after the motors
start, then the camera will start to record video automatically.