User's Manual

aee.com
16
Charging contacts
Power indicator
Statu indicator
Power / function key
6.2 Description of Keys and Indicators:
No. Name Description
[ 1 ] Power/function key
In power-off state, long press it for 3s to power on the tracker. Press and hold the Power button until the red
indicator is lit. After 3 seconds, the green indicator starts blinking, indicating the startup is completed.
In power-on state, long press it for 3s to power off the tracker. Press and hold the Power button until the green
indicator goes out. After 3 seconds, the red indicator goes out, indicating the shutdown is completed.
Initial code pairing: press it for 3 times at an interval of 2s to trigger the code pairing function�
[ 2 ] Power indicator Power indicator is red
[ 3 ] Statu indicator Status indicator is green
[ 4 ] Contacts
Charging contacts�
※
Note:
1. Code pairing process: turn on the tracker and trigger its code pairing function; turn on the quadcopter, and its built-in 5.8GHz module will auto proceed with the
code pairing process. In the code pairing process, the distance between the tracker and quadcopter should be less than 10m.
2. After the code pairing function is triggered, the tracker will auto exit the code pairing state if the code pairing process is nished successfully within 30s. If no code
pairing device is found or the code pairing process fails within 30s, the tracker will also auto exit the code pairing function.
6.3 Indicators on the tracker
SN Status Red indicator Green indicator Notes
1 During startup process ON
Green indicator blinks after 3
seconds
Press and hold the Power button until the red indicator
is lit. After 3 seconds, the green indicator starts blinking,
indicating the startup is completed�
2
During shutdown
process
Red indicator goes out
after 3 seconds
OFF
Press and hold the Power button until the green indicator
goes out. After 3 seconds, the red indicator goes out,
indicating the shutdown is completed�
3 No device to pair with / Blinking fast Blinking 10 times per second
4 During code-pairing / Blinking fast Blinking 5 times per second
5 Searching GPS signal / Indicator’s blinking sequence 1 Remaining on → blinking fast for 3 times
6 GPS signals are OK / Green indicator remains on
7 Abnormal system / Green indicator goes out Restarting is required
8 Charging battery Blinking slowly / Blinking 1 times per second
9 Battery charged fully Remaining on /
10 Low battery power Blinking fast / Blinking 10 times per second
6.4 Operating Instructions
6.4.1 Operating Steps:
Component Startup Time
Turn
on the
quad-
copter
Start
the APP
on the
mobile
device
Perform
the takeoff
operation of
the quadcopter
Turn the mode
switch of the
remote control to
“F-M”
The quadcopter
will enter the
follow-me video
recording mode.
Camera 20s
Repeater 22s
Remote control 10s
Tracker 10s