User's Manual

- 43 -
Select the waypoint you want to y to in the Flight Mission Editor (the color of the selected waypoint
is green); then click [Fly to] on the toolbar, and the aircraft will y to this waypoint; after reaching this
waypoint, the aircraft will hover.
Only one target waypoint can be added every time.
3) Edit Flight Mission in the Air
You can continue to edit the flight mission after the aircraft enters the hover state. The following
operations can be realized:
a Continue to edit the ight mission; click [Edit Waypoint] to continue to add waypoints and edit waypoint
information; click [Finish Editing] after editing is completed (at this moment, it is not needed to clear
the ight mission; you can directly upload the current mission to overwrite the existing mission in the
aircraft). Click [Download Mission] to ensure the mission is correct and then execute the action of [Auto
Fly].
b The action of [Fly to] can be executed, as shown in Step 2 (at this moment, missions saved in the
aircraft still exist).
c Click [Clear Mission] to clear the ight missions in the aircraft and the content of missions shown on
the map; at this moment, if [Auto Fly] is clicked, the aircraft will stay in the hover state.
Before the aircraft executes the Auto Fly command, please rst download the mission to verify if the
ight mission uploaded to the aircraft is correct.
13 Go Home
If [Go Home] is clicked during flight or after the aircraft enters the hover state, the aircraft will
automatically return and hover over the take-off position.
The altitude of the homeward course is the altitude of the last waypoint.
14Landing
Click [Auto Landing] after the aircraft returns, and the aircraft will automatically land vertically.
1) There might be minor difference between the landing position and the take-off position.
2) To avoid unpredictable consequences, do not randomly click “Auto Landing” in the course of ight.
3) To close the ground station, please rst shut it down normally and then turn off the main power
switch.
15One-button Auto Fly
Before ight, please rst check if the requirements for One-button Auto Fly are satised (the throttle is
in the lowest position; the Manual/Auto switch is in the Auto mode; at least one waypoint is uploaded),
and refer to the descriptions in “Precautions”; Make sure ALL requirements for One-button Auto Fly are
satised.