User's Manual

- 18 -
switch and rotate the PTZ control knob, and the relevant indication bars will pulsate correspondingly;
the functions of roll, pitch, throttle, course, automatic ight switch and angle adjustment of airborne
camera can be checked.
Notice: During servo checking, please make sure that the aircraft power switch is in the OFF
state, in order to avoid accidental startup of the aircraft.
* Joystick Calibration
Touch “[Start]” for joystick calibration in the interface of “Servo Checking” in the above step; turn the
left and right joysticks for 5-10 circles by 360° to enter the state of joystick calibration; indication bars
of roll, pitch, throttle and course will pulsate correspondingly; click “DONE” to finish the calibration
process. Carry out servo checking after completion of calibration; it is OK if servo checking shows
normal result; otherwise, recalibration is required.
Notice: During joystick calibration, please make sure that the aircraft power switch is in the OFF
state, in order to avoid accidental startup of the aircraft.
* Camera Setting
Touch “ ” to enter the interface of “Airborne Camera Setting” shown below: Video Recording
Settings
, Photo Shooting Settings , and Local Settings of Airborne Camera )
Video Recording Settings
1) Setting Image Resolution