User's Manual
- 13 -
Preparations before Take-off
1. Remove the lens cap of the airborne camera.
2. Check the batteries of the aircraft and the remote control to see if the battery level is high enough (the
recommended voltage for the aircraft is above 16V, and the remote control above 12V); in case of low
battery level, please replace the battery.
3. Check the propellers of the aircraft to see if they are tightened.
4. Make sure that the manual/automatic ight switch of the remote control is in the manual ight mode.
5. Check the servo; in case of any anomaly (indication bars do not jump or indication is inaccurate during
checking), please calibrate the joystick. (For servo checking and joystick calibration, please make sure
the power switch of the aircraft is in the OFF state, in order to avoid accidental take-off of the aircraft.)
6. Turn off the power switch after the aircraft is placed at the take-off position; to ensure safety, there
should be no obstacle within the radius of 5-10m around the take-off position.
7. Turn on the power switch of the aircraft; for outdoor ight, GPS satellite positioning is required; take-off
is allowed only when the GPS signal strength indicator is greater than or equal to 6.
8. Before take-off, please make sure that only one aircraft is started; to avoid accidents, it is forbidden to
simultaneously start two aircrafts.
9. Before take-off, please make sure that the video and radio antennas have been properly installed to
avoid inuence on the ight and the video receiving distance or damage to the transmitter modules
inside the aircraft and the remote control.
10.When the remote control is used to control the aircraft, please make sure that the option of “Send
joystick data” in the ground station software is not checked before take-off; when the ground station
joystick is used to control the aircraft, please make sure that the remote control is in the OFF state
before take-off.
Control the Flight with the Remote Control
The remote control is specially developed for AEE unmanned aircraft system to make it convenient for
controlling the ight of the unmanned aircraft. The remote control can independently control the ight of
the aircraft, and can simultaneously display the ight status of the aircraft and the real-time images from
the airborne camera.
Guide for Components of the Remote Control
and Description of Their Functions
Shutter button