User's Manual

- 8 -
4) After confirmation of the current value, the voltage value begins to pulsate: ;
press
DEC
STATUS
INC
to select the corresponding voltage of the battery; press
START
ENTER
for conrmation after
the voltage is adjusted to the proper value.
5) After setting all parameters, hold
START
ENTER
for 2 seconods, and the charger begins to detect the battery;
after successful detection, press
START
ENTER
to start charging, or press
BATT
TYPE
STOP
to cancel charging.
6) After charging is completed, the charger sends out sounds, and the screen displays the following
information:
Charging completed
Charged capacity (mAh)
Battery voltage after
charging is completed (V)
To avoid short circuit resulted from misoperation, DO NOT pull out the charger wires during charging.
4 Complete Charging
After charging is completed, please disconnect the battery from the charger in the sequence shown
below:
First disconnect
the power plug
Then pull out the
charging interface
Finally pull out the
charger wires
To avoid short circuit caused by accidental contact between the positive and negative connectors,
which may further result in damage of the battery or other safety accidents, DO NOT pull out the
charger wires from the charger before the power plug is disconnected.
Precautions for Use of Lithium Battery
1. Do not disassemble or restructure the battery;
2. Do not short-circuit the battery;
3. Do not use the battery near heat sources;
4. Do not drop the battery in water or get it wet;