User's Manual

Unmanned Aircraft System
Professional·Advanced
- 5 -
2. Set parameters and start charging
After the battery is connected to the charger, set the parameters for the charger as follows:
1) Press “START” to select a battery type, and call out LiPo BATT; the screen displays:
.
2) Press “START” for confirmation, and the screen displays:
; then press “DEC.” or “INC.” to
select LiPo BALANCE, and the screen displays:
.
3) Press “START” again for confirmation, and the current value begins to pulsate:
; press
“DEC.” or “INC.” at this moment to decrease or increase the current value; press “START” for confirmation after
the current is adjusted to the proper value.
4) After confirmation of the current value, the voltage value begins to pulsate:
; press “DEC.”
or “INC.” to select the corresponding voltage of the battery; press “START” for confirmation after the voltage is
adjusted to “25.2V”.
5) After setting all parameters, long press “START” for 2s, and the charger begins to detect the battery; after
successful detection, press “START” to start charging.
3. Complete charging of the battery
After charging is completed, the charger sends out beep sounds, and the screen displays the following information:
At this moment, you can disconnect the charger from the battery according to the following steps:
Charging completed
Battery voltage after charging is completed (V)
Charged capacity of battery (mAh)
First, pull out the yellow
connector that is connected
to the battery
Then, pull out the two
connectors of the flat cable
in the directions of arrows.
Last, pull out the charger
wires, or leave them there
for future charging