User's Manual

Unmanned Aircraft System
Professional·Advanced
- 18 -
13 Sunshade
Reduces the influence of strong light when the operator
is viewing information on the screen
14 Reserved button /
15 Reserved button /
16 Manual/auto mode switch Switches between manual and auto fly modes
17 Right joystick
Manually controls the flight of the UAV, including roll and
pitch channels
18 Pitch trim button Trims the pitch channel
19 Roll trim button Trims the roll channel
20 One-key go home button Controls the aircraft to go home autonomously
21 Reserved button /
22 Reserved button /
23 Remote control power switch Turns on/off the remote control
24 Airborne video recording button
Controls video recording of the airborne device
Turn it downward to enable airborne video recording;
turn it upward to disable airborne video recording
25 Reserved button /
26 Reserved button /
27 Strap hole Hangs the strap
28 Reserved button /
29 Reserved button /
30 Local recording button
Saves a video currently displayed on the display
terminal to the local memory
31 Airborne photo shooting button Controls photo shooting of the airborne camera
32 Reserved button /
33 Menu button It allows you to enter or exit the menu setting interface
34 One-key take-off button Controls autonomous take-off of the aircraft
35 One-key landing button Controls autonomous landing of the aircraft
36 Airborne zoom knob Controls zooming of the camera
37 PTZ control knob
Controls up-and-down rotation of the PTZ; the lens
angle can be adjusted; the maximum and minimum
angles of elevation are 15° and -90°, respectively
Preparations for the Remote Control
Antenna Installation
Install the antennas shown below at the corresponding positions of the remote control and clockwise tighten them.
The shapes of antennas and the antenna ports on the remote control are shown as follows:
Video antenna
Radio antenna