User's Manual

Unmanned Aircraft System
Professional·Advanced
- 13 -
Install the Airborne Camera
1. There are two HDMI video cables and one PTZ control cable at the position where the airborne camera is
installed, as shown in the figure below:
2. Properly connect the HDMI cables and the PTZ control cable to the airborne camera (insert the white HDMI cable
into the port marked with a white block), as shown in the figure below:
3. Attach the two clamping pins of the PTZ (as shown in the red circles) by aligning with the PTZ sockets (as directed
by the red arrows), as shown in the figure below:
The yellow po
r
ts are fo
r
HDMI cables
The white port is for PTZ control cable
Insert the white HDMI cable
Insert the black HDMI cable
Insert the white PTZ control cable