User's Manual

Unmanned Aircraft System
Professional·Advanced
- 6 -
To avoid short circuit caused by accidental contact between the positive and negative connectors, which may
further result in damage of the battery or other safety accidents, DO NOT pull out the charger wires from the charger
before the power plug is disconnected.
Precautions for Use of Lithium Battery
1. Do not disassemble or restructure the battery;
2. Do not short-circuit the battery;
3. Do not use the battery near heat sources;
4. Do not drop the battery in water or get it wet;
5. Do not charge the battery near fire or in the sun;
6. Do not impact or drop the battery;
7. Do not use the battery when it is severely damaged or deformed;
8. Do not charge the battery in reverse polarity or over-discharge it (charging the battery in reverse polarity or
over-discharging it may result in swelling, fluid leaking, cell breakdown or even explosion of the battery);
9. Do not connect the battery in reverse polarity;
10. Any waste battery should be recycled in an environment-friendly way;
11. If the battery will be idle for a long time, the battery should be taken out and charged once every six months to
24V for storage, so as to maintain the battery performance and prolong its service life.
Charge the Battery of the Remote Control
1. Install the battery
Step Illustration Description
Step 1
Install the battery into the battery
compartment by aligning with the
metal contacts.
Step 2
Turn the battery snap rightward
and meanwhile push the battery
cover upward, as shown in the
figure; when the battery cover is
properly installed, the battery snap
will automatically rebound to the
left side.
2. Connect the adapter
First, connect the power cord of the adapter to the adapter; then, insert the adapter plug into the power outlet; last,
insert the round end of the adapter into the DC jack of the remote control.