User's Manual

Green light remains ON Repeater power supply is normal.
Red light blinks Repeater is charging, or repeater power is running out, please charge as
soon as possible.
Red light remains ON Charging is completed.
※ It is not recommended to turn on the repeater while it is charging.
Pairing Button
When the repeater is on, long press the Pairing button for 2 seconds, the repeater will automatically
restart for code re-pairing. Short press the Pairing button to check repeater power level
Short press Pairing
button
Press Pairing button once:
If Power Indicator blinks once, indicates that repeater has over 80%
charge remaining.
If Power Indicator blinks twice, indicates that repeater has over 50%
charge remaining.
If Power Indicator blinks three times, indicates that repeater is running
out of power.
Long press Pairing
button (2 seconds)
Repeater restarts and you can re-pair codes.
5.2 How to use
Charging the Repeater
Connect the repeater to the Micro USB port through the repeater adapter to charge the repeater. It
takes about 2 hours to fully charge.
※ Before each flight, make sure the repeater has sufficient charge.
Switching on the Repeater
(1) Toggle repeater power switch to ON to switch on the repeater.
(2) Wait until the WiFi indicator blinks blue, indicating that the repeater works properly.
(3) While using this process, ensure the repeater’s LED side faces you, and try to ensure that
visibility between the repeater and quadcopter is unobstructed, to obtain maximum
communication distance.
※ After the flight is completed, in addition to switching off the quadcopter and transmitter, be
sure to turn off the repeater, or else the repeater’s battery will be depleted.