User's Manual

Unmanned Aircraft System
Professional·Advanced
- 19 -
Notice: Please make sure that the video and radio antennas have been properly installed to avoid influence
on the flight or the video receiving distance, or damage to the UAV or the transmitter module inside the
remote control.
Sunshade Installation
Insert the sunshade along the groove direction until the snap at the back of the sunshade is attached to the snap
holder on the remote control, as shown in the figure below:
Sunshade removal
To remove the sunshade, use your fingers to hold the two sides of the snap; pull the sunshade snap outward to
separate it from the snap holder; then, pull the sunshade upward along the groove direction to separate the
sunshade from the remote control. See the figure below:
Video antenna port Video antenna port
Radio antenna port