User's Manual

- 2 -
* Without authorization from SHENZHEN AEE TECHNOLOGY CO.,LTD, do not disassemble or modify
AEE UAS products..
* During outdoor ying, the aircraft can be started only when the GPS signal strength indicator is greater
than or equal to 6.
Forced take-off when the GPS signal strength indicator is lower than 6 may result in the following
consequences:
a. When it is beyond the operating range, it may be impossible for the aircraft to go back to the take-off
position;
b. When the remote control signals are jammed, it may be impossible for the aircraft to go back to the
take-off position;
c. When switching the automatic ight mode, the aircraft may not hover at the current position;
d. When “One-key Go Home” is enabled, it may be impossible for the aircraft to go back to the take-off
position;
* During servo checking and joystick calibration, please make sure that the power switch of the aircraft
is in the OFF state, in order to avoid accidental take-off of the aircraft.
* Please keep away from running parts; when the aircraft propellers are running, do not touch and do
keep away from any rotating part; especially, keep one’s head away from the propellers to avoid injury.
Meanwhile make sure the aircraft away from small metal objects to avoid the danger may caused
because they are adsorbed by the aircraft.
* Make sure there should be no person or obstacle within the radius of 5-10m around the take-off and
landing point. Before operating the AEE UAS products, should make the aircraft in ight safety zone
away from the crowd and be sure to pay attention to your personal safety and that of others.
* Keep away from humid environments; prevent water vapor from entering the aircraft which may cause
damage to electronic components or result in unpredictable consequences.
* Please do not use this product in atrocious weather conditions like thundering and raining to ensure
personal safety and aircraft safety.
* Keep away from heat sources, which may lead to aging, deformation or even melting and damage of
thermoplastic materials of the aircraft.
* Do not y when the wind force is above Level 4, in order to prevent the aircraft from being damaged or
lost due to loss of control.
* For editing of waypoints, please make sure each waypoint is high enough in altitude (relative to the
take-off position of the aircraft) to avoid intersection between the air route and mountains or buildings,
which may result in collision and damage.
* If the map fails to be loaded when the ground station software is started, please close the software,
connect to the network and restart the software; or make use of data management of Google Maps to
restore map data.
* Under the precondition that network service is available at the ground station, if Google Earth fails to