User Manual

aee.com
8
2.4 Install the Camera Frame
Two types of camera frame can be mounted on AP9 quadcopter: 1. S50/S51/S60/S71/S70/OM51S/OM60S/OR60S/OR71S/S40 and other series of cameras can be
mounted in Q45. 2. G3 cameras can be mounted in Q44;
2.4.1 Install the Connector and Camera Cage:
(1) Install the cage seat onto the quadcopter and lock the screws, as shown in Fig. 10 (a).
(2) Install the camera frame onto the cage seat and lock the screws, as shown in Fig. 10 (b).
Figure10(a)
Figure10(b)
Figure10
2.4.1 Install the Connector and Camera Cage:
(1) Install the camera into the camera cage, as shown in Fig. 11 (a); reverse installation shall be avoided.
(2) Make sure the camera is installed in correct direction, and then lock the camera cage cover, as shown in Fig. 1
1 (b).
Note: The above gure is for Q45 camera cage; the same operation steps also apply to Q44.
+ =
Figure11(a) Figure11(b)
3 Preparing Propellers
AEE AP9 adopts 10-inch propellers, with black and gray color propeller nuts. Propellers are consumable items. Please purchase these accessories separately, if
necessary.
3.1 Introduction
Propellers Gray (1045) Black (1045 P)
Diagram
Assembly Location Attach to the motor shaft without "P" mark Attach to the motor shaft with "P" mark
Installation Location
Lockup: Tighten propeller in this direction
Symbol Description Unlock: Loosen propeller in this direction