User Manual

5
aee.com
5
Battery Specications
Type Li-Po Battery
Capacity
5300mAh
Charging ambient temperature
0°C-50°C
Discharging ambient temperature
-20°C-50°C
Charge / discharge ambient relative humidity
< 80%
Please carefully read and strictly comply with this manual before use. Users take full responsibility for any problems caused due to failure to follow instructions.
1.2 Charging the Quadcopter battery
(1) Connect the charger to an AC power source (100-240V, 50 / 60Hz). Please use a power adapter, if necessary.
(2) While charging, the battery charger indicator turns red.
(3) When the battery charger indicator turns green, the battery is fully charged. Disconnect the charger and battery when charging is complete.
Figure 6
1.3 Quadcopter Battery Installation
Push the battery into the battery compartment in the correct direction (Figure 7). After the battery is properly installed, a “click” sound will be heard, indicating that the
battery has been fastened.
Figure 7
1.4 Caution
(1) Do not directly pull out the battery when the Quadcopter is switched on as it may damage the power supply connector.
(2) For long term storage, discharge the battery to 40%-50% power, and store in a specied battery box. Discharge/charge the battery once every three months to
maintain battery life.
(3) Replace the battery after it has been discharged over 300 times. Completely discharge a battery prior to disposal.
(4) Replace the battery if your current battery swells up or is damaged in any way, to avoid re and explosion.
(5) Do not charge expanded or damaged batteries.
(6) Pay attention while charging batteries to prevent accidents. Always charge batteries on a non-ammable surface, and never near any ammable materials.
(7) Battery safety is extremely important. Please refer to Disclaimer for more precautions.
An incorrectly installed battery may
cause
● Bad contact
● Affect ight safety
● Inability to take off.