User Manual
aee.com
16
3 Common Troubleshooting
3.1 Solution for transmitter joysticks center (neutral) position errors
When there is a big error in neutral position of transmitter joysticks, the motors cannot start when performing CSC. Errors in Transmitter joysticks neutral position
usually occur in two cases:
1. When quadcopter is ON and the joystick (except throttle) is not in neutral position-Solution: Move all T
ransmitter joysticks to neutral position, and re-start the
quadcopter, to re-record the neutral position. If problem persists, it may be caused due to case.
2. Transmitter joysticks have been trimmed, leading to deviation in neutral position, i.e., there is a large asymmetry in quadcopter joystick position-Solution:
Recalibrate the Transmitter .
a) Make sure the quadcopter is powered off. Toggle S2 to Position-3
S2:
, then power on the Transmitter. The photo capture indicator (green) blinks. Then
move both joysticks clockwise and counterclockwise twice, ensuring the joystick touches the maximum positions. Afterwards, release the joystick and toggle S2 to
Position-1
S2:OK
, the Video Indicator lights up (green), and calibration is completed.
(b) Re-start the quadcopter, and pay attention whether or not it starts properly.
If the problem cannot be solved by the above methods, please send back the transmitter to our factory for repair.
3.2 How can quadcopter land smoothly?
Before performing CSC, pull down the left joystick to less than5% ofthe joystick level, and then execute CSC. This way you can land the quadcopter smoothly.
Limited Warranty
AEE products are guaranteed against manufacturing defects, AEE's sole obligation in the event of such defects during this period is to repair or replace the defective
part or product with a comparable part or product at AEE's sole discretion. Except for such repair or replacement, the sale, processing or other handling of this
product is without warranty, condition or other liability even though the defect or loss is caused by negligence or other fault. Damage resulting from use, accident, or
normal wear and tear is not covered by this or any warranty. AEE assumes no liability for any accident, injury, death, loss, or other claim related to or resulting from
the use of this product. In no event shall AEE be liable for incidental or consequential damages relating to or resulting from the use of this product or any of its parts.
Because of possible user resealing error, this product is not warranted against leakage in waterproof housing or any resulting damage. Returns or replacements of
parts and/or products may be subject to shipping, handling, replacement and/or restocking fees.
If you are experiencing a problem with an AEE purchase, please contact our Customer Support Team by visiting our website www.aee.com .
For product warranty period and conditions, please refer to www.aee.com for details.
Tip: If you bought this product from an AEE authorized dealer, we would recommend that you rst contact them for technical support issues
This User Manual is subject to change without prior notice.
You can check the ofcial AEE website for the latest updated version.