User's Manual

AEE Aerial Photography Equipment
Professional·Advanced
- 22 -
photography equipment beep beep --- beep beep… continuous
Level 1 alarm for low battery of the aerial
photography equipment
The arm lights flash slowly with beep sounds: beep --- beep ---
beep… continuous
Alarm for low battery of the remote control Beep --- beep beep… continuous
Remark: Upon Level 2 alarm for low battery of the aerial photography equipment, it will automatically land at the
current position rather than go home.
In case of Level 1 alarm for low battery of the aerial photography equipment, please cautiously decide whether flight
can be executed (it is suggested that it shall return for replacement of the battery before flying), to prevent flight
accident that may be caused by low battery of the aerial photography equipment or the remote control! Upon Level 1
alarm for low battery of the aerial photography equipment, it is suggested that the throttle joystick should not be
pushed to the top in order to prolong the flight time. If full-throttle flight is kept long after Level 1 alarm for low battery,
the equipment will enter Level 2 low battery state ahead of time.
Specification
Description Specification
Flight mode Manual control flight, auto hover, nose orientation lock function
Endurance time About 25min
Maximum cruising speed 25m/s
Maximum remote control range 500m
Flight altitude (relative altitude) 150m
Normal take-off/landing wind speed Below Level 3
Working temperature -20°C ~ +60°C (when it is below 0°C, pay attention to thermal
insulation of the battery; the battery performance is better when
it is above 0°C.)
Working humidity 5% ~ 95%RH
Storage temperature -40°C ~ +85°C
Airborne camera HD 1080P
Net weight of aerial photography equipment 1.2KG
Troubleshooting
Before test flight, please read the “Operation Instruction” first. If normal take-off fails, please perform troubleshooting
according to the table below. If the problem still exists, please contact us immediately. To avoid unnecessary loss,
please do not operate blindly!
Fault Solution
Speeds of the four motors are obviously inconsistent
with each other after startup (some run fast, while
some run slowly)
(1) Make sure the aerial photography equipment is placed
on a flat ground before self-checking
(2) Use the pitch and roll joystick of the remote control to
optimize take-off process.
The aerial photography equipment cannot be started
after successful self-checking
Check the manual/auto switch of the remote control to
make sure it is in the manual state
Normal take-off fails when the throttle lever is pushed
forward after the aerial photography equipment is
(1) Check the four propellers of the aerial photography
equipment to see if they are installed onto the motors