User's Manual

2
3
Installation
1. Installation: install AEE DW10 onto your camera (as shown below), and it will auto recognize AEE DW10 and enter the
standby state when you turn on your camera.
Note: Rollei WiFi Transmitter DW-10 does not support
hot plugging function. Please turn off your camera
before installing Rollei WiFi Transmitter DW-10.
WiFi Indicator / Blue
DW10 Indicator / Green
Charging Indicator / Red
Power Key (Press it to turn on/off the WiFi; long
press it for 3s to check the battery level)
2. Long press the power key for 3s:
1) If the blue indicator remains on for 3s and then goes out, the battery power is higher than 65%;
2) If the green indicator remains on for 3s and then goes out, the battery power is between 35% and 65%;
3) If the red indicator remains on for 3s and then goes out, the battery power is lower than 35%.
Prompt for low battery: in case of low battery, the red indicator will ash quickly; if the WiFi is turned on, you will hear an
alarm for low power; the alarm will not stop until 10s after the WiFi is turned off.
3. Charging: connect AEE DW10 to the power supply or computer through the attached charger or USB cable (as shown
below).
AEE DW10 has the overcharge protection function. In the charging process, the red indicator will ash slowly. When
the battery is fully charged, the red indicator will remain on. (Each full charge can support about 70-minute use).