User's Manual

- 25-

8.Standby mode:

A.Non-voice control standby:

Push the VOX switch to “OFF” and turn the power switch

to “ ON” , the system will start working and it will enter

preview state after finishing initialization. In case of no

any mission and operation, the system will auto enter

standby power-saving mode at the end of the auto

standby time set. Press “ Record” or “Shutter” key at this

time, or remote control any key on the remote control,

the system will be waked up.

Note:

a:To press keys on TFT screen in standby mode cannot wake

up the system;

b:The LCD segment screen does not display anything in

standby mode.

B.Voice control standby:

Push the VOX switch to “ON” and turn the power switch

to “ ON” , the system will start working and it will enter

preview state after finishing initialization. In case of no

any mission and operation, and the environmental voice

is lower than 65dB continuously, the system will auto

enter standby power-saving mode at the end of the auto