User's Manual

- 20-
c.Continuous shooting:
Press “M” key to enter the camera setup interface, press
“ >” key to move the cursor to “ ” , select the menu
“ Continuous Shooting” , and press “ OK” key to set the
continuous shooting interval time as 0s, 2s, 3s,5s,10s,
20s,30s. Press “ M” key to exit the setup interface after
setting the interval time. Press “Shutter” at this time, and
SD20 will start shooting one photo every 2s, 3s,5s,10s,
20s,30s, till to press “Shutter” key again to stop.
d.Self-timer:
Press “M” key to enter the camera setup interface, press
“>” key to move the cursor to “ ” , select the menu “ Self-
timer”, and press “OK” key to set the delay time as 0s,5s
or 10s. Press “ M” key to exit the setup interface after
setting the delay time. Press “Shutter” once at this time,
and SD20 will start the timer and shoot a photo at the
end of the delay time.
Note:
a.If the memory space gets full, the system will give the
message 'Insufficient Memory' (viewing on TFT display
screen), and go back to the preview mode；
b.The setting of self-timer delay time is in effective once.
5.Voice recording
Press “M” key to enter the camera setup interface, select
the menu “ Shoot Mode” , press “ OK” key to enter the
selection interface, press “ <” or “ >” key to select “ ” ,
press “ OK” key to confirm your selection, and finally
press “M” key to exit the setup interface. Press “Record”
key to start recording, and the green indicator twinkles
slowly, the TFT screen displays the voice recording icon,
and the timer is started.