User's Manual

- 18-
b.If the battery power is low in video recording, the
system will save the current file recorded and give the
message “Low Battery” on TFT display screen until SD20
is turned off or auto enters standby mode;
c.If the memory space gets full in video recording, the
system will save the current file recorded, give the
message “ Insufficient Memory” on TFT display screen,
and go back to the preview mode. The video recording
duration on LCD segment screen also will be stopped
displaying;
d.In cyclic recording mode, the system will auto save a file
e ve r y 1 5 m i n u t e s a n d t h e c a pa c i t y i s a b o ut
500MB(720P)/650MB(1080P)
e.After it is fully charged, it can continuously record
720P/1080P and the record time is about 2 hours and 30
minutes; it can continuously record WVGA and the
record time is about 3 hours; it can continuously record
QVGA and the record time is about 3 hours and 30
minutes. The continuous voice recording time is about
3.5 hours;
f.In voice control mode, the system will start recording
when the environmental voice is higher than 65dB and
the g reen i ndic at or wi l l t wink l e s lowl y; if t h e
environmental voice is lower than 65dB and it lasts for 2
minutes, the system will auto save the 2-minute file
recorded, the green indicator will be off, the red
indicator will remain bright (the corresponding record
stopping prompt will be displayed on LCD segment
screen), and it returns to the preview state;
g.To press “ +” or “ -” key in voice recording mode cannot
execute voice increasing/reducing operation; however,