Installation Instructions

put the stainless steel plate on the wall at an appropriate height, drill four holes with an impact
drill, place the rubber plug in the hole, fix the stainless steel plate to the wall with tapping
screws.( If the tail wire comes out of the back of the box, it is necessary to make a hole in the wall
to facilitate the wiring. If the tail wire comes out from the bottom, it only needs to be fixed and
routed with a large white plastic trunking.) As shown in the figure.
壁挂出线图 Wires outlet diagram of Wall-mounted
后盒出线 outlet on the back 底部出线 outlet at the bottom
线缆接线说明图，如下 Cable wiring diagram, as follows